a.
Turn the screw 2 & 3 turns counterclockwise.
b
.
Now play a plate/DISC/RECORD and check whether the PU-ARM is
up
when
the needle enters the outlet groove (the needle can be set at 1/4 of the end of the plate).
c.
Repeat this operation mentioned under
a and b
until the needle continues to run in the outlet
groove.
d
.
Now turn the screw 1/4 turn clockwise and check as indicated
under
b
.
e.
Repeat the procedure
under
d
until PU arm
goes up again
when the needle enters the outlet
groove.
f.
Now check the operation with
different plates
for normal as well as microgrovel. If it happens that
the PU-Arm sometimes goes up slightly, the screw should be turned 1/4 of a turn clockwise, with which
the mechanism is set.
3
.
If the desired result
can not be achieved
with the adjustment described in point 2, then the adjustment
(2-VI
) must be checked.
VI
The arm does not raise at the end of a played, but continues to run in
the exit slot...........
1.
The driver (1) on the steering hook
is bent and slides underneath the carrier (2), without touching it. The driver (1) must be bent slightly
upwards in such a way that the driver (2) is hit at about 1 mm from the bottom. See size in drawing.
48
Summary of Contents for AG1000
