OccuSwitch DALI
User Guide
Page 33
Calibration with remote control
1 Place a light meter on a representative
place .
2 Measure the light level and adjust it by
pressing the up or down
Arrow keys
.
3 If the light level is adjusted to the correct
value, press the
Save
button
.
The luminaires blinks to indicate that the
setting has been stored .
D
Note
At all actions, stay close to the OccuSwitch DALI and
point the remote control towards the sensor .
4 .2 .5
100 hour burn-in mode
Most lamp manufacturers advise not to dim (to a low level)
the fluorescent lamps for a period of 100 hours prior to
normal use, in order to maintain light quality at (very) low
dimming level .
The OccuSwitch DALI 100h burn-in mode adapts all
dimming functions during this period, to make sure that
the lights are not dimmed . Only during walk test (to test
the installation) and commissioning, dimming is allowed to
make the necessary adjustments .
1 Point the remote towards the
OccuSwitch DALI and press 100h to
enable or to disable the parameter .
The luminaires will flash once to confirm
the selection .
When the 100h burn-in mode is active,
the LEDs on the OccuSwitch DALI are
continuously green when the lights are
switched on . (The LED may blink when
motion is detected) .
4 .2 .6
Request application mode
The OccuSwitch DALI controller has 10 pre-defined
application Modes . The default application mode is Mode
1 (Cell office) . The IRT9090 can be used to request the
actual application mode .
1 Point the remote towards the
OccuSwitch DALI and press
Mode?
The luminaires dim, and then start to flash .
The number of light flashes is equal to the
actual application mode, as displayed in
figure below .
4 .2 .7
Mass programming
To ease the commissioning process of a whole installation,
the IRT9090 can be pre-programmed with the application
mode, the background level, the power-up state and
infrared group address . These four settings will remain
stored in the IRT9090 remote, and are sent each time the
green Send button of the remote is pressed . For resetting
these values, see section 4 .3 .
70% G
min
100 h
group
link?
mode?
mode
power up background IR group
reset
add
pir
delay
daylight RF channel
0
0
off
save
on
I/II
O)))
A-G
zone
%
on/off
8
7
9
50% E
40% D
60% F
5
4
6
20% B
10% A
II
30% C
PL
BMS
W/C
2
1
3
test
config
scene
70% G
min
100 h
group
link?
mode?
mode
power up background IR group
reset
add
pir
delay
daylight RF channel
0
0
off
save
on
I/II
O)))
A-G
zone
%
on/off
8
7
9
50% E
40% D
60% F
5
4
6
20% B
10% A
II
30% C
PL
BMS
W/C
2
1
3
test
config
scene
70% G
min
100 h
group
link?
mode?
mode
power up background IR group
reset
add
pir
delay
daylight RF channel
0
0
off
save
on
I/II
O)))
A-G
zone
%
on/off
8
7
9
50% E
40% D
60% F
5
4
6
20% B
10% A
II
30% C
PL
BMS
W/C
2
1
3
test
config
scene
100%
1%
Press “mode?” button
5 flashes = Mode 5
