Philips 39PFL4398T/60, Service Manual

Page: 22 / 139

Mechanical Instructions EN 22 TPN10.1E LA 4.
2013-Oct-18
back to
div. table
2. Unplug the connector from the Control Board IR/LED
panel.
3. Gently release the clip that holds the panel and take it out
from the bezel.
When defective, replace the whole unit.
4.3.6 LCD Panel
1. Unplug all the connector cables of the boards.
2. Gently take all the speakers out.
3. Lift the subframe with SSB + PSU combination panel,
Control Board IR/LED panel from the LCD panel and put it
aside.
Warning:Cause the panels of TPN10.1E series are bolt-on
panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.4 Assembly/Panel Removal (for 40" & 42" & 47")
Instructions below apply to the 40PFL3188T/60, but will be
similar for other series models.
4.4.1 Rear Cover
Refer to Figure 4-12 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3]that secure the rear cover. Refer to
Figure 4-12 for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-12 Rear cover removal [1]
19530_107_130724.eps
130724
1
M4 × 10
Q3 × 8
1
1
1
1
2
2
2
2
2
2
2
2
2
2
2
2
2
M3 × 6
3
3