Mechanical Instructions
4.
4.4.5
Stand bracket
1.
Remove all fixation screws of the bracket.
2.
Lift the bracket from the set.
4.4.6
Control Board IR/LED Panel
1.
Remove the stand bracket, as described earlier.
2.
Unplug the connector from the Control Board IR/LED
panel.
3.
Gently release the clip that holds the panel and take it out
from the bezel.
When defective, replace the whole unit.
4.4.7
LCD Panel
1.
Unplug all the connector cables of the boards.
2.
Gently take all the speakers out.
3.
Lift the subframe with SSB, PSU, Control Board IR/LED
panel from the LCD panel and put it aside.
Warning:Cause the panels of TPN10.1E series are bolt-on
panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.5
Assembly/Panel Removal (for 20" & 22" & 24")
Instructions below apply to the 24PFL3108H/12, but will be
similar for other series models.
4.5.1
Rear Cover
Refer to
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2] that secure the rear cover. Refer to
for details.
2.
At the indicated areas [3] the cover is secured by clips. Be
very careful with releasing those.
3.
Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-15 Rear cover removal
4.5.2
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS [1] connector that connect
with the SSB.
Caution: be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2].
3.
Remove all the fixation screws [3] from the SSB.
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket.Refer to
19531_101_130905.eps
130905
3
3
2
1
1
2
3
