Philco PDA 870, User Manual

Page: 27 / 112

EN - 25
04/2011
2011
Did you forget to load any dishes into the dishwasher?
You can load forgotten dishes into the dishwasher at anytime, until the dishwashing detergent compartment
opens up.
1. Stop the dishwasher by slightly opening the door.
2. As soon as the spraying arm stops, you can open the door fully.
3. Load the forgotten dishes into the dishwasher.
4. Close the door, the dishwasher will resume after about 10 seconds.
After the end of the washing cycle
After the washing cycle has fi nished a sound signal will be made. Turn off the dishwasher using the (ON/OFF)
switch, close the water inlet and open the door of the dishwasher. Wait a few minutes before taking dishes out
of the dishwasher so that you do not handle the dishes while they are hot and more susceptible to breakage,
and they will dry better too.
• The program has ended only if after a signal the display shows "--:--", only then is the program at an end.
• Turn off the dishwasher using the (ON/OFF) switch.
• Shut off the water inlet!
• Carefully open the door.
• Hot dishes are sensitive to shocks. For this reason allow the dishes to cool down for 15 minutes and only
then take it out of the dishwasher.
• Open the door of the dishwasher, leave them partly open and wait a while before taking the dishes out.
The dishes will be cooler and will dry better.
• Take out the dishes.
• It is normal for the dishwasher to be wet inside.
• First take out the dishes from the lower rack and only then from the upper rack. This will prevent the dishes
in the lower rack from becoming wet from the water dripping from the upper rack.
WARNING!
It is dangerous to open the dishwasher door during a wash because you could be scalded by hot
water.