Philco PDA 870, User Manual

Page: 10 / 112

EN - 8
04/2011
2011
Cold water supply connection
Connect the water supply hose to the cold water inlet with a 3/4" thread and check that you have tightened
it properly. If the hoses are new or have not been used for a long time, fl ush them out with water, to be sure
that they are clean inside with all dirt removed. If you do not do this, you risk clogging up the water inlet and
damaging the appliance.
Hot water supply connection
You can also connect hot water to the dishwasher (supplied by the central system, heated by the heating
system), if the water temperature does not exceed 60 °C. This will shorten the washing cycle by 15 minutes and
the washing effi
ciency will be slightly reduced.
The connection must be carried out in the same way as for the cold water.
WARNING!
To prevent water from staying in the hose, close the water inlet into the dishwasher.
(This does not apply to dishwashers with the aqua-stop function.)
Connecting the drain hose
Insert the drain hose into the waste water pipe with a minimum diameter of 4 cm or leave it lying in the sink
and ensure that it is not bent or dented. Use a special plastic bracket supplied with the appliance. The hose
must be at a height of 40 to 100 cm above the ground. The loose end of the hose must not be submerged in
water so that reverse water fl ow does not occur.
Hang the drain hose using one of the methods A, B, C.
Front part
NOTE
The hose must be
at a height of 40 to
100 cm above the
ground.
The loose end must
not be submerged in
water.
Drain hose
Hang the bracket directly next to the sink.
Drain hose bracket
Sink
MA
X 1000
mm
MIN
400 mm
Ø 40 mm