Phihong USA Corporation • 47800 Fremont Blvd. Fremont, CA 94538 • Tel: 1.510.445.0100 Fax: 1.510.445.1678
www.phihong.com or www.midspans.com
-18-
4.2
GUI System Control and Information:
The System Control and Information panel on the GUI supports the main system level parameters for
the μP. It also displays information about the PoE ID, firmware revision and system status.
Figure 20: System Setup, Control, Information, and Port Commands
The system level parameters that can be configured are:
• System Reset
– This is a function that allows the GUI to reset the software on the μP. (If System
Reset is set and the GUI does not respond, user must click “Reset GUI”)
• Firmware Download
– This feature is used to download new application/firmware codes onto
the μP. Please refer to the Phihong website www.midspans.com for the latest firmware for your
midspan –
POE Firmware.
Note:
Please allow the GUI a few seconds to respond to the commands selected. DO NOT click or
check any commands simultaneously. If a command is selected more than once within two
seconds, the GUI may not respond properly.
The “
Save Parameters to Flash
” button will save system and port parameters to flash memory, so that
they can be used to the firmware across reboots of the μP.
The “Restore Factory Defaults” button will reset the defaults in the firmware, and clear any stored
data in the flash memory, the device will reset automatically. After the device has successfully reset,
the “System Status” will read “0.” Click “Reset GUI” if necessary.
To make the factory defaults
permanent, the user must click “Save Parameters to Flash.”
The System ID field specifies the hardware revision of the PoE device. The firmware version is
represented in a major/minor format.
System ID/Name – click “Edit” to edit/change the description of the system. If you click “Cancel”, the
previous description will be set for the system.
To make this permanent the user must click “Save
Parameters to Flash.”
