Phihong USA Corporation | 47800 Fremont Blvd., Fremont, CA 94538 | 1.510.445.0100 | www.phihong.com
18
•
Click on the control button “
Cycle
”
in each row to reset that port, if the corresponding port
Output-LED is already on (or No Connection), it will be turned off for several seconds and
then turned on again (or No Connection). If the Output-LED is off, it will be turned on (or
No Connection).
•
Click the button
Enable All Ports
below the table, the port Output-LEDs will be turned
on if connected to a valid device or it will display a status “No Connection” if a port is not
connected to a valid end device.
•
Click the button
Disable All Ports
below the table, all port Output-LEDs will be turned
off.
•
Click the button
Cycle All Ports
in the last row, all port Output-LEDs will follow one of
the following actions: If the ports are already “ON” then the ports will be “On” (or No
Connection)
→
Off
→
Turning On…
→
On (or No Connection). If all ports start turned
off then the sequence will be Off
→
Turning On…
→
On (No Connection), depends on
their original states.
