Phase 3 J-3 CUB 370 RTF Operating Instructions Manual Download Page 18

8

  Landing should always be done into the wind with the wing level.

  To prepare for landing from normal flight, make a shallow turn so that the airplane is flying directly into the wind.  Make small turns 

to level the wing, then pull back completely on the throttle control stick to turn off the motor.  When you do this, the airplane will gradu

-

ally descend straight ahead.

  Allow the airplane to gradually descend.  If the airplane seems to be descending too fast, gently pull back on the right-hand 

control stick to make the airplane pitch up to level flight.  This will bleed off speed and slow the descent.  Once the airplane has slowed 
down, release the control stick and allow the airplane to continue its descent.  Once the airplane is about 15 feet (5metres) off the 
ground, make sure that the wing is level and continue a shallow descent.  Just before touch-down, gently pull back on the right-hand 
control stick to level the airplane with the ground for landing. 

 

 

If you need to turn the airplane while descending for landing, make gentle, shallow turns.  Making steep turns may 

cause the airplane to stall and crash.  Also, you should just try to land anywhere on your flying field, as long as it's into the wind.  
Don't try to land in a particular spot.  You can do that once you've mastered flying the airplane.

  After landing, unplug and remove the flight battery from the fuselage, then turn off the transmitter.  Allow the flight battery to cool 

completely, then recharge it for your next flight. 

LANDING THe J-3 CuB 370 RTF

PRO TIP

 

 

When the airplane climbs you will notice that it will begin to lose speed.  You'll also notice that the airplane will gain 

speed when the airplane descends.  If you climb too steeply, the airplane may slow down so much that it stops flying and stalls.  
Conversely, if you descend too steeply, the airplane may fly so fast that you begin to lose control.  For these reasons, we suggest 

using small, gentle control inputs to prevent this from happening.

  To turn the airplane, you need to move the right-hand control stick in the direction you want the airplane to turn, either right or left.  

To make smooth, gentle turns, gently move the control stick in the direction you want the airplane to turn and 

HOLD

 the control stick 

in that position for a second or two and the airplane will begin to turn.  After the airplane has turned in the direction you want, move 

the control stick gently in the opposite direction to level the wing, then allow the control stick to return to center.

 

 

The longer you hold the control stick over, the tighter the radius the airplane will turn in.  We recommend gentle turns 

until you are proficient with the flight characteristics of the airplane.

WARNING

  Do not hold the right-hand control stick either right or left for more than a few seconds.  Hold it over only long enough 

for the airplane to begin to bank and turn.  Holding the control stick over longer can cause the airplane to roll too steeply and the 

nose to drop rapidly, possibly causing a crash to occur.

  When going into a turn, the airplane will have a natural tendency to lose some altitude.  Unless you want to descend, you should 

gently pull back on the right-hand control stick to keep the airplane level during the turn.  The steeper the turn the more altitude the 
airplane will lose and the more you will need to pull back on the control stick.

  You should continue to fly, making circles and S-turns for about 3 minutes or so.  This will give you plenty of time for landing.  Re

-

member for now to keep the motor at full power and use gentle control inputs to keep the airplane level throughout the entire flight.  
Also remember to keep in mind that when you make turns the airplane will want to lose altitude, so you'll need to pull back gently on 
the control stick to keep the airplane level.

 

 

If there is any wind when you are flying, you will notice that when the airplane turns into the wind it will slow down and 

climb slightly.  When this happens, gently move the control stick forward to pitch the airplane down if you don't want the airplane to 

climb.  When the airplane turns down-wind (with the wind), the airplane will speed up and descend slightly.  You should gently pull 

back on the control stick to keep the airplane from descending too much while flying down-wind.

  After some practice, you will learn how to minimize the amount of up and down, and right and left movements of the airplane and 

be able to control the airplane in a smooth and graceful manner.

When flying toward you, you will notice that it seems that the right and left controls are reversed.  An easy way to learn to 

overcome this confusion is to move the right/left control stick toward the "lower" side of the wing to level the airplane.  
You can also try to "envision yourself in the cockpit."  This helps a lot when trying to coordinate right and left turns when 

the airplane is flying toward you.

PRO TIP

PRO TIP

PRO TIP

Summary of Contents for J-3 CUB 370 RTF























Reviews: