Petit Auto Wash Inc.
360-t Installation Manual
www.PetitAutoWash.com
P a g e
|
24
Accutrac 360-t Tunnel
3.
Appendices
3.1.
Appendix A: Multi-Conductor Cable Stripping Procedure
Tools Required:
Measuring Tape, Light Colored Marker, Pick, Wire Stripping Tool, Flush Cut Snips, Electrical Tape
•
Mark out the desired length of the multi-conductor cable, if space permits, allow extra length in case
a wire gets nicked
•
Set the wire stripping tool’s cutter depth to ¾ of the thickness of the outer insulation, the wire
stripping tool should
NOT
cut deeper than the outer layer.
•
To strip the cable: Latch the wire stripping tool onto the top of the cable. Spin the tool in the
direction shown. Make sure the first 360
degree cut is inline and not spiraling.
Note:
Make a test cut at the very end of the cable to verify correct cut depth.
•
DO NOT REMOVE
the wire stripping tool. Press and hold the center button and run the tool down
the length of the cable, eventually sliding the tool off the end of the cable. Do not let go of the
button until the wire stripping tool is separated from the cable.
•
At the 360 degree cut flex the cable repeatedly until the outer layer of the cable separates. At the
end of the cable, carefully pick at the lengthwise slice, and then peel back the outer layer by hand.
•
Note:
Always pick away from the inner layers of the cable.
Te
st Cut
