Petit Auto Wash Inc.
360-t Installation Manual
www.PetitAutoWash.com
P a g e
|
19
Accutrac 360-t Tunnel
1.8.
Bridge Mount LED (144w):
The Bridge Mount LED is optional and attaches to the exit side of the Bridge.
Note: For machines produced before 1/15/2015, refer to additional LED Retrofit instructions before
proceeding with this installation.
Unpack the LED Light bar. Measure and find the centerline of the light bar. Position brackets so they are
26 1/2” from center and tighten the set screws, then tighten the thumb wheels that control the angle.
The LED Light bar has quick disconnect leads on both sides. Find the cord that has a waterproof plug
inserted into the quick disconnect. This end of the LED Light must be oriented to the driver side. Bundle
and tie wrap the cord to the D.S. light bracket as shown below.
Using the included 1/4-
20 x 1” bolts, fender washers and locking nuts, plac
e the LED light on top of the
Bridge L brackets, and tighten the fasteners. Fender washers should go on the LED light side.
Land the wiring in the Bridge Junction Box using the existing multi-conductors as shown in the LED
schematics.
At the 360 Control Panel, if necessary, install the LED Relay bank onto the Motor terminal strip din rail at
the bottom of the panel. Wire the LED 24VDC power supply, light controller, and relay bank per the LED
schematics.
Bridge Mount LED
