Peter electronic VersiComb II 230-3, Installation And Commissioning Instructions

Page: 9 / 26

8 VC II 230/400-3...15
7.1 LED indicators
If, after braking, the „fault“ LED is illuminated and the „bypass“ LED is not flashing, no motor
standstill has been detected. The motor standstill threshold detection has to be adapted as
described in the chapter „Adjusting the standstill threshold“, on page 14.
LED – line (green)
- Illuminated
Operational state
- Mains voltage is applied,
VersiComb II is ready.
LED – bypass (yellow)
- Changes flashing frequency
- Illuminated
- Flashing 2x
a
- Flashing 3x
a
- Flashing 4x
a
- Flashing 5x
a
- Flashing 7x
a
- Flashing 9x
a
a. ... repeatedly with a short pause
Operational state
- Motor is in the start-up phase
- Start-up is finished
- Heat sink or motor temperature too high
- Microcontroller error
- max. Braking time exceeded (3x in succession)
- Trigger failure
- Mains fault or synchronization error
- Start contact defective/charred
LED – fault (red)
- Illuminated
Operational state
- Fault, observe flash. indication of bypass-LED