Peter electronic VersiComb II 230-3, Installation And Commissioning Instructions

Page: 17 / 26

16 VC II 230/400-3...15
Adjusting the standstill threshold
Before the first start the potentiometer „n0“ must turn to left stop.
If the braking current switches off before the motor has come to a standstill, turn the
potentiometer in 0,5 steps from „n0=0“ to be found a setting which switches the braking current
after the motor has come to a standstill.
After the motor has come to a standstill the braking current switches off approx. 1,5 s.
Note:
The positioning of the braking current as the braking can affect that the
motor standstill is not properly detected. Then control the switched off the
braking current by a second braking.
Warning!
It must be ensured that the specified switching frequency is not exceeded,
otherwise the motor may overheat.