PESA RCP-CSD, Manual

Page: 36 / 68

RCP-CSD
28 Chapter 3 – Operation
Hot Take Mode
Hot Take Mode – Follow Switch
In Hot Take mode, a source is selected first, then a destination is selected. The switch is taken immediately
on all levels when the destination is selected.
When in Hot Take mode, the display will show
HOT TAKE
in the Mode field as shown in Figure 14.
PRESET SOURCE HOT TAKE PAGE 1
DESTINATION DESTINATION DESTINATION DESTINATION
SOURCE SOURCE SOURCE SOURCE
DESTINATION DESTINATION DESTINATION DESTINATION
SOURCE SOURCE SOURCE SOURCE
Figure 14. Hot Take Mode Display
To take a follow switch in Hot Take mode:
1. Press HOT TAKE to enter Hot Take mode. The MULTI-BUS / MULTI-LEVEL and HOT TAKE
key LEDs will be on. The display will show
HOT TAKE
in the Mode field, and the currently
selected source, if any, in the Selection field.
2. Select the source to be switched by one of these two methods:
•
Use Data Keys to select a source.
•
Use PRESET / COPY (see page 23).
•
Use PREV and NEXT to scroll through all sources in the Source Include List until the desired
source is displayed in the Selection field.
3. Press PAGE UP and PAGE DOWN until the destination appears in the display.
4. Take the switch by pressing the display panel key corresponding to the desired destination.
5. Steps 3 and 4 may be repeated as required using the same source.
Hot Take Mode – Breakaway Switch
Breakaway switches cannot be performed in Hot Take mode.