PESA RCP-CSD, Manual

Page: 32 / 68

RCP-CSD
24 Chapter 3 – Operation
Multi-Bus Mode – Follow Switch
To perform a follow switch in Multi-Bus mode, first a destination is selected, then a source is selected, then
the switch is taken on all levels.
When in Multi-Bus mode, the display will show
MULTI-BUS
in the Mode field as shown in Figure 11.
PRESET SOURCE MULTI-BUS PAGE 1
DESTINATION DESTINATION DESTINATION DESTINATION
SOURCE SOURCE SOURCE SOURCE
DESTINATION DESTINATION DESTINATION DESTINATION
SOURCE SOURCE SOURCE SOURCE
Figure 11. Multi-Bus Mode – Follow Switch Display
To take a follow switch in Multi-Bus mode:
1. Select the destination as described in “Multi-Bus Destination Select Mode” on page 22.
2. Press DEST / SALVO to exit Multi-Bus Destination Select mode. The DEST / SALVO key LED
will turn off. The Display Panel key LED for the selected destination will turn on and the Data
field pair will change to inverse video.
3. Select the source by using Data keys, PRESET / COPY (see page 23), or PREV and NEXT to
scroll through all the sources in the Source Include List. The source will be displayed in the
Selection field. If the source displayed is blinking, it is not a valid source. Press CLEAR / STORE
to clear a source from the Selection field.
4. Press TAKE / CHOP to take the switch. The Data field pairs will remain in inverse video, and
current status will be displayed.
Multi-Bus Mode – Breakaway Switch
Breakaway switches cannot be performed in Multi-Bus mode.