PESA RCP-CSD, Manual

Page: 34 / 68

RCP-CSD
26 Chapter 3 – Operation
Salvo Execution
Salvos are executed in one of two ways:
•
By scrolling through the salvo list to select a salvo, and then executing it.
•
By pressing a Data key configured as a Salvo key. This will immediately execute the salvo.
When in Salvo mode, the display will show SALVO in the Selection Legend field and MULTI-BUS in the
Mode field as shown in Figure 13.
SALVO SOURCE MULTI-BUS PAGE 1
DESTINATION DESTINATION DESTINATION DESTINATION
SOURCE SOURCE SOURCE SOURCE
DESTINATION DESTINATION DESTINATION DESTINATION
SOURCE SOURCE SOURCE SOURCE
Figure 13. Salvo Mode Display
To execute a salvo:
1. Press DEST / SALVO and hold for approximately one second to enter Salvo mode. The DEST /
SALVO LED will be flashing and the MULTI-BUS / MULTI-LEVEL key LED will be on. The
display will show
SALVO
in the Selection Legend field and
MULTI-BUS
in the Mode field.
2. Select the salvo by either using Data Keys, or using PREV and NEXT to scroll through all the
salvos in the system configuration. The salvo will be displayed in the Selection field.
3. Press TAKE / CHOP to take the switch. The Data field pairs will remain in inverse video, and
current status will be displayed.
Chop
To chop two sources, take a switch using the first source, then:
1. Press MULTI-BUS / MULTI-LEVEL to enter Multi-Bus mode. The MULTI-BUS / MULTI-
LEVEL key LED will be on. The display will show
MULTI-BUS
in the Mode field.
2. Select the destination as described in “Multi-Bus Destination Select Mode” on page 22.
3. Select the second source to be chopped by using Data keys, PRESET / COPY (see page 23), or
PREV and NEXT to scroll through all the sources in the Source Include List. The source will be
displayed in the Selection field. If the source displayed is blinking, it is not a valid source. Press
CLEAR / STORE to clear a source from the Selection field.
4. Press TAKE / CHOP and hold for approximately one second to chop the two sources. The Data
field pairs will remain in inverse video, and current status will be displayed. The TAKE / CHOP
key LED will be flashing.
To cancel the chop, press TAKE / CHOP again.