MAINTENANCE
5
Section 5
page 5.2
Maintenance
RCP–48X
5.4 Corrective Maintenance Continued:
ë
Pack the equipment securely and label with the
correct address. Proper packaging saves
money. The small amount of extra care and
time it takes to cushion a part or unit properly
may prevent costly damage while in transit.
Make certain that the address is both legible and
complete. Failure to do so often results in delay
or even loss.
Factory Repair Service
If desired, equipment or boards may be returned to the factory (transporta-
tion prepaid) for repair. Refer to the General Assistance and Service
information sheet in the front of this manual.
NOTE: Contact PESA Switching Sytems' Service Department (listed on
the General Assistance and Service information sheet in the front of this
manual) for a RMA# prior to shipping.
Adjustment/Alignment
The RCP–48X has no adjustments.
Troubleshooting
Troubleshooting an RCP–48X requires the routing switcher system to be
used as a test fixture. The Panel does not function except as part of the
system. The only troubleshooting which can be accomplished without
opening the Control Panel is to check input power (from plug-in power
module).
To open the Control Panel for troubleshooting, remove the front cover and
disassemble the unit as far as required to gain access to the component
side of the circuit boards. Place the disassembled panel on a non-con-
ducting surface and arrange the parts so the unit can be operated. You
must be able to operate the pushbuttons and observe the resulting status
indicators. You must also have sufficient access to the boards to measure
voltage or observe waveforms.
Procedure: Put the RCP–48X through the operating sequence described
in the operation section. Refer to Section 3.
