Perrot VP3 VAC, Maintenance And Operating Instructions, Page: 7 / 29

TDP074e.doc Rev. 28.11.2016 Page 7 / 29
Perrot REGNERBAU CALW GmbH Industriestraße 19 ‐ 29 / D ‐ 75382 Althengstett / Germany
Tel.: +49 ‐ 7051 ‐ 162 ‐ 0 / Fax: +49 ‐ 7051 ‐ 162
–
133
E ‐ mail: perrot@perrot.de / Construction team e ‐ mail: technik@perrot.de
5. Assembly, set ‐ up and installation
5.1 Hazard warnings
If any impurities get into the sprinkler, it is possible that the sprinkler could
be destroyed and that fitters could be injured. Therefore flush out the line
thoroughly before connecting the water supply.
Any unexpected emergence of a jet of water can lead to serious injury.
Therefore make sure that the installation has been fully completed before
turning on the water supply.
5.2 Installation instructions

The thread connection on the pop ‐ up sprinkler is 2" FT.

For the thread seal use hemp and sealing compound, e.g. Fermit Spezial or
teflon tape.

The pop ‐ up sprinkler should be fitted in accordance with the 'Perrot VP3 pop ‐
up sprinkler installation diagram' (see next page). In order to avoid any load
pressure on the main line, you should definitely use a flexible connection.

Providing a drainage pit directly connected to the drainage, as shown in the
installation diagram, is very much recommended.

For screwing in the connection joint the housing or housing edge of the pop ‐ up
sprinkler can be firmly held or clamped.