Perrot VP3 VAC, Maintenance And Operating Instructions, Page: 19 / 29

TDP074e.doc Rev. 28.11.2016 Page 19 / 29
Perrot REGNERBAU CALW GmbH Industriestraße 19 ‐ 29 / D ‐ 75382 Althengstett / Germany
Tel.: +49 ‐ 7051 ‐ 162 ‐ 0 / Fax: +49 ‐ 7051 ‐ 162
–
133
E ‐ mail: perrot@perrot.de / Construction team e ‐ mail: technik@perrot.de
6.4 Full ‐ circle irrigation
For full ‐ circle irrigation the spring stops need to be removed.
First, the sprinkler module needs to be removed from the housing.
(See point 8.3).
Pull spring stop apart at both ends only to such extent that
they can just be slid off.
If the spring stops get overextended, it will not be possible to
use them any more for back ‐ and ‐ forth operation.
Gently pull both spring stops apart
and remove downwards.
Now splay the spring stops over
the sliding pipe and pull off.
New spring stops are fitted in
reverse order.
Any overextension of the spring
stops must be avoided, as
otherwise it can no longer be
certain that they will fit tightly and
it will no longer be possible to set
the irrigation sector's switch ‐ over
point when reverting to sector
operation.