Permobil Chairman Playman, Service Manual

Page: 19 / 28

19
Control panel & Seat control panel
Fig. 37. The Control panel and
Seat control panel bracket.
Fig. 40. The Seat control panel
electrical connector.
Fig. 38. The Control panel and
Seat control panel fixings.
Fig. 39. Removing the Seat control panel lid.
Control panel
Removal
1. Put the circuit breaker in the “OFF” position,
see page 20.
2. Disconnect the control panel cable by pulling
the connector at the rear of the control panel
straight outwards.
3. To remove the control panel, remove the
screws holding the common bracket for the
control panel and Seat control panel, see fig. 37.
Remove the control panel bracket by removing
the two screws on the rear of the control panel,
see fig. 38.
Installation
Installation is the reverse procedure.
Seat control panel
Removal
1. Remove the cover of the Seat control panel by
pulling it straight upwards. If the lid is stuck,
you can carefully use a screwdriver to pry
between the lid and the lower part of the end
of the box, see fig, 39.
2. You can now lift the circuit board and cable out
of the box.
3. Disconnect the cable from the circuit board by
pulling the connector straight upwards,
see fig. 40.
4. To remove the seat control panel, remove the
screws holding the common bracket for the seat
control panel and Seat control panel, see fig. 37.
Remove the seat control panel bracket by
removing the two screws on the underside of
the box, see fig. 38. Note the position of the
bracket for refitting.
Installation
Installation is the reverse procedure.