Perle 833IS, User Manual

Page: 58 / 340

Configuring the 833IS
42 Perle 833IS User Guide
easy to create a successful initial configuration. This configuration can then be
modified using the Cisco style commands via Telnet.
Attaching to
the
Telephone
Network
You will need the appropriate cable to attach the 833IS to the telephone network.
The ISDN BRI interface uses an RJ-45 connector. The required telephone network
cables are shipped with your 833IS unit.
1.
Ensure that the 833IS is powered down.
2.
Attach the cable between the ISDN BRI interface port and the line termination
point. For a U interface, this will be the LT (Line Termination) point. For an S/
T interface, this will be a NT (Network Termination) point.
What's next?
At this point, installation is complete. Proceed to Chapter 4 for instructions on
loading Firmware and "Section 2: Configuration" for instructions on configuring the
833IS, You can now verify that remote users can dial into the 833IS and access the
services. Also, you can install Perle Dial-Out software on LAN PCs, and verify that
the Dial-Out is functioning correctly.
If you are using Perle Remote Access Client software, please see the Perle Remote
User’s Guide for details on software installation and operation.
If you are using Perle Dial-Out software, please see the Perle Dial-Out User’s Guide
for details on software installation and operation.