Perle 833IS, User Manual

Page: 283 / 340

Appendix 2: AT Command Set
Perle 833IS User Guide 267
F9 Select V.32 bis 12000 line modulation. (RC144)
F10 Select V.32 bis 14400 line modulation. (RC144)
SPEAKER ON DURING ANSWERING.
N0 Turn off automode detection.
N1 Turn on automode detection.
O0 Go on-line.
O1 Go on-line and initiate a retrain sequence.
Q0 Allow result codes to DTE.
Q1 Inhibit result codes to DTE.
Sn Select S-Register as default.
Sn? Return the value of S-Register n.
=v Set default S-Register to value v.
? Return the value of default S-Register.
T Force DTMF dialing.
V0 Report short form (terse) result codes.
V1 Report long form (verbose) result codes.
W0 Report DTE speed in EC mode.
W1 Report line speed, EC protocol and DTE speed.
W2 Report DCE speed in EC mode.
X0 Report basic call progress result codes, i.e., OK, CONNECT, RING, NO
CARRIER (also, for busy, if enabled, and dial tone not detected), NO
ANSWER and ERROR.
X1 Report basic call progress result codes and connections speeds (OK,
CONNECT, RING, NO CARRIER (also, for busy, if enabled, and dial
tone not detected), NO ANSWER, CONNECT XXXX, and ERROR.
X2 Report basic call progress result codes and connections speeds, i.e., OK,
CONNECT, RING, NO CARRIER (also, for busy, if enabled, and dial
tone not detected), NO ANSWER, CONNECT XXXX, and ERROR.
X3 Report basic call progress result codes and connection rate, i.e., OK,
CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX,
BUSY, and ERROR.
X4 Report all call progress result codes and connection rate, i.e., OK,
CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX,
BUSY, NO DIAL TONE and ERROR.
&C0 Force RLSD active regardless of the carrier state.
&C1 Allow RLSD to follow the carrier state.