26 . TGA 4000 Installation and Hardware Guide
Safety Precautions for the TGA 4000
WARNING
AVERTISSEMENT
Be sure that all instrument operators read and understand
the follow ing precautions. It is advisable to post a copy of
these precautions on or near the instrument itself.
Assurez-vous que tous les opérateurs d'instruments lisent
et comprennent les précautions suivantes. Il est conseillé
de publier une copie de ces précautions sur ou près de
l'instrument lui-même.
The following precautions must be observed when using the TGA 4000:
•
Never switch off the computer until it has completed its normal shutdown procedure.
•
Never press the Reset button on the computer if the Pyris software appears to
malfunction. Press the
CTRL–ALT–DEL
keys simultaneously and select Task Manager.
From the Task Manager, close the Pyris software.
•
Never remove the outer instrument cover of the TGA 4000 without shutting the
instrument down and disconnecting its power cord from the power source.
•
Before connecting the TGA 4000 to the power outlet, check the voltage setting and
fuse.
•
The TGA 4000 requires a good earth ground that is common to the earth ground of the
computer.
•
Do not disconnect cables or tubes from the TGA 4000 while the instrument is on.
•
Never open the furnace when it is at a high temperature.
•
Always observe the proper startup and shutdown procedures with the TGA 4000 and all
related instruments.
•
Do not operate the instrument in a cold room. The ambient temperature and the
temperature of the instrument should be between 10 °C and 30 °C.
•
Use proper lifting posture when lifting the analyzer. The TGA 4000 with autosampler
weighs 19 kg. Lift the autosampler from underneath. Never attempt to lift the analyzer
by the autosampler (if installed) or by any cables attached.
•
When cleaning the instrument, consult PerkinElmer if there is any doubt about the
compatibility of decontamination or cleaning agents with parts of the equipment or with
material contained in it.
Summary of Contents for TGA 4000
