Perkin-Elmer STA 6000, Installation And Hardware Manual

Page: 38 / 84

38 . STA 6000 Installation and Hardware GuideSTA 6000 Installation and Hardware Guide
Set Up the STA 6000 System Components
Place the STA 6000 on your laboratory bench. Do not plug in the power cord until instructed.
The computer and printer should already be on the bench and installed according to each
instrument’s instructions.
Be sure to set up all of the system components listed below before switching on the
STA 6000:
• Select the correct voltage
• Install the purge gases
•
Remove the shipping/alignment tool
•
Install the sensor
• Install the cooling device
Select the Correct Voltage for the STA 6000
The STA 6000 is able to accept the following two voltages: 100–120 V and 200–240 V
(50/60 Hz).
The STA 6000 is configured and shipped with 220–240 V selected. Selection of the voltage
can be done at the AC inlet plug at the rear of the STA 6000.
First check whether the voltage selection corresponds to the voltage in your laboratory. This
can be seen easily: the voltage range with the text in an upright position and the arrow
pointing at the small line represents the voltage that has been selected.