Performa
™
Professional Series
- 52 -
Cleaning
Cleaning of the Device
• Switch off the device and disconnect it from the power supply.
• The device can be cleaned with a damp cloth.
• Use lukewarm water and a non-abrasive liquid household
cleaner (non-abrasive, non-alcohol content solution).
• If a more sterile cleaning is needed, use a cloth moistened with
an Antimicrobial cleaner.
CAUTION
Do not submerse the device in liquids. Should the unit
accidentally become submersed, contact the dealer or
authorized service center immediately. Do not attempt to use
a system that has been wet inside until inspected and tested
by a certified service technician. Do not allow liquids to enter
the ventilation holes.
Cleaning of Display Panel
Use a soft and dry cotton or micro fiber cloth to clean the panel.
To remove fingerprints or grease, use a non-abrasive glass
cleaning agent. Apply a small amount of the cleaning agent to
a soft cotton cloth and carefully clean the panel.
CAUTION
• Do not spray the cleaning agent directly on the glass panel.
• Do not use cleaning agents that contain strong alkali, lye, acid,
detergents with fluoride or detergents with ammonia.
Care and Storage of Electrodes
(Performa
™
Stimul8 and Combin8 devices only.)
• The life of the electrodes varies depending on skin conditions,
storage temperature,the amount of use, type of stimulation and
stimulation site.
• If electrodes begin losing adhesion, gently rub one or two drops
of water onto the gel surface and allow them to quickly air-dry.
Over saturation with water will reduce the adhesive properties.
• Then place them back on the protective liner and in the original
resealable bag sealing tightly to prevent air from drying out the
electrodes.
• Between uses, store in a cool dry place.
CAUTION
• The electrodes are intended for single patient use only .
• If irritation occurs, discontinue use and consult your clinician.
• Always use the electrodes with CE mark, or are legally marketed
in the US under 510(K) procedure.
Maintenance
