9
INSTALLATION INSTRUCTIONS
INSTALL THE AIR CONDITIONER IN
THE CASE
1.
Slide the air conditioner into
the case. Do not push on the
controls or the finned coils.
Make sure the air conditioner
is firmly seated.
2.
Reinstall the locking bracket and screw
removed earlier.
3.
Reconnect the ground wire to the air conditioner
using the screw removed earlier.
IMPORTANT: The ground wire must be reinstalled to
ensure a proper ground.
4.
Attach the front grille frame to the case by inserting
the tabs on the grille frame into the slots on the front
top of the case. Push the grille frame in and install
the 2 Type F screws at bottom left and right side of
front panel.
Guide the lever carefully
through the grille frame
as you push it in.
5.
Secure the front grille frame to the case with one
Type C screw.
6.
Reinstall the filter.
7.
Reinstall the inlet grille. Connect power.
IMPORTANT:
• If you turn off the air conditioner, wait at least 3
minutes before turning it back on. This prevents
the air conditioner from blowing a fuse or tripping a
circuit breaker.
• Do not try to operate your air conditioner in the
cooling mode when outside temperature is below
61°F (16°C). Do not try to operate your air
conditioner in the heating mode when outside
temperature is over 86°F (30°C). The inside
evaporator coil will freeze up, and the air conditioner
will not operate properly.
NOTE:
In the event of a power failure, your air
conditioner will operate at the previous settings when
the power is restored.
WARNING
EXCESSIVE WEIGHT HAZARD!
To reduce the risk of personal injury, we advise you have the assistance of 2 or more
individuals while moving and installing the air conditioner. Failure to do so can result in
back or other injuries. A room air conditioner can weigh between 70–240 lbs.
