2
0
1
8
-0
7
84
PACTware Multi-Input/Output Device Type Manager
Adjusting the Process Data Settings
1. Use the different fields and pull-down menus to enter the information you require for your
process.
2. Click on
Apply
to confirm.
10.3.8
Tab "Configuration"
This tab gives you several text-only fields that you can fill in as your process requires. Configure
the sensor wire check. The settings apply to all sensor input modes.
Figure 10.20
Channel "Configuration" tab
The tab "Configuration" contains the following channel information and parameters:
Process Data Parameters in the Online Mode
The following parameters contain read-only information displayed in the online mode.
Section "OUT":
■
OUT:
Process variable of the discrete input block in Auto mode. User-specified value
defined in the manual mode or during operation.
The following 2 pull-down menus are active in case the actual mode is set to
“
Manual
”
. In
this case, you can make the settings for online diagnostic simulation purposes.
- OUT status type
- Alarm limits
More Information
For more information on OUT status types, see chapter 4.3.2.
For more information on OUT reset counter (OUT_C_RESET), see chapter 4.2.
