PACTware Multi-Input/Output Device Type Manager
2
0
1
8
-0
7
69
10.3
Basic Device Setup in Sensor Input Mode
The
“
Basic device setup
”
is the initial setting you must make before going into any further
device setup or channel parameterization. In this section you set the MIO device up as a sensor
input. Depending on the settings you made, the subsequent menus change accordingly.
Figure 10.9
Channel "Basic Setup" tab: Select the device type
Section "Device mode":
Select the required device mode with the radio button.
Section "Ident number":
Select the required ident number with the radio button.
More Information
For more information on the device modes, see chapter 2.2.
Note!
Changing the PROFIBUS Ident Number in the Online Mode
If you use the menu command in online parameterization, a change of ident number selection
takes immediate effect. The device is automatically rebooted with the ident number selected.
More Information
For more information on ident numbers, see chapter 3.3.
