71
3
Ta
king
Pict
ures
1
Press the four-way controller (
2
) in
A
mode.
The [Drive Mode] screen appears.
The drive mode changes each time the button is pressed. You can also
change the mode using the four-way controller (
45
).
To select
Z
, press the four-way controller (
3
) after choosing
g
, and
then use the four-way controller (
45
).
2
Press the
4
button.
The setting is saved and the camera
returns to capture status.
About the red-eye phenomenon
Taking pictures using the flash may cause the subject’s eyes to appear red in
the resulting picture. This phenomenon occurs when the light from the flash is
reflected in the subject’s eyes. It can be reduced by illuminating the area around
the subject or moving closer to the subject and zooming out to a wider angle.
Setting the flash mode to
d
is also an effective way of reducing red eyes.
If the subject’s eyes appear red despite such precautions, they can be corrected
by the red-eye compensation function (p.112).
Saving the Flash Mode setting
1
p.87
Selecting the Drive Mode
g
Self-timer
Use this mode when you want to be included in a group
picture. The picture is taken approximately ten seconds
after the shutter release button is pressed.
Z
2 sec. Self-timer
Use this mode to avoid camera shake. The picture is taken
approximately two seconds after the shutter release button
is pressed.
j
Continuous
Shooting
Each time an image is taken, it is saved in the memory
before the next image is taken. The higher the image
quality, the longer the interval between shots.
You can continue shooting until the capacity of the SD
Memory Card or the built-in memory is full.
q
Burst Shooting
The number of recorded pixels is fixed at
f
for the 4:3
aspect ratio and
1
for the 16:9 aspect ratio.
MENU
O K
O K
O K
OK
D r i v e M o d e
D r i v e M o d e
D r i v e M o d e
S e l f - t i m e r
S e l f - t i m e r
S e l f - t i m e r
C a n c e l
C a n c e l
C a n c e l
