13
PENTALIFT EQUIPMENT CORPORATION
M065R27
August 30, 2021 1:39 PM
ULTRAHOOK UHR40 VEHICLE RESTRAINT
ELECTRICAL REFERENCE CHART
ELECTRICAL REFERENCE - 1.5 HP
Length of branch
circuit which will have
a 2% voltage drop
at full load current
(copper wire) ft/m.
The values given
are intended to be a
rough wiring guide
only.
Be sure to check all
local electrical codes
before wiring.
AWG
115/1/60
230/1/60
230/3/60
380/3/50
460/3/60
575/3/60
14
60.3 ft/
18.4m
168.7 ft/
51.4m
406.7 ft/
124m
704 ft/
214m
1035.1 ft/
315.5m
12
38.1 ft/
11.6m
152.5 ft/
46.5m
268.2 ft/
81.8m
646.7 ft/
197.1m
10
60.6 ft/
18.5m
242.6 ft/
73.9m
426.8 ft/
130.1m
Note: Calculations are based on 30
degrees C Ambient
8
96.4 ft/
29.4m
385 ft/
117.5m
678.2 ft/
206.7m
6
153.2 ft/
46.7m
612.9 ft/
186.8m
Approximate Motor Current
(full load) TENV Unit
19 A
9.5 A
5.4 A
3.7 A
2.7 A
2.2 A
9.
_
Trim the height of the brush weather seal assemblies so that they overlap the 2” step at the bottom front of the
restraint by 1” and the dock leveler front angle by approximately 1”. Ensure that the two halves of the brush weather
seal assemblies meet at the center of the pit opening. Fasten brush weather seal assemblies to the dock face using
1/4 concrete screws of the type that are removable and re-useable (see
Figure 5: Mounting the Brush Weather Seal
on page 9). Note: If the trimming operation removes some bolt holes and fasteners, then the cover plate and
brush weather seal carrier may need to be re-drilled. This will depend on how much material is removed from the
brush weather seal assemblies to suit restraint vertical opening and dock height.
10.
_
Confi rm that all steps of the installation instructions have been completed. Fill out the following information.
Installer Name (Print)
Installer Signature
Date Installation Completed
