Pentair Pool and Spa Control System SunTouch, Installation And User Manual

Page: 33 / 88

25
SunTouch Pool and Spa Control System Installation and User’s Guide
Advanced Menu (8/13): Reset Factory
SunTouch system configuration data is stored and retained in “Flash” memory in an EEPROM located on the
SunTouch motherboard. The SunTouch user system configuration data can be erased to restore the factory
defaults settings. If the optional QuickTouch QT4 wireless controller is installed it will need to be reconfigured.
Reset to factory default settings
Menu button: Select the Advanced menu.
Right button: Press this button until Reset Factory setting is displayed.
Up/Down button: Select Yes to continue. Select No to exit the setting.
Right button: Press this button to continue. “Erase Memory” is displayed.
Up/Down button: Select Yes to continue. Select No to exit the setting.
Right button: Select Yes to erase system data and restore the factory default
settings. The display will return to the main screen. CAUTION: This procedure will
erase all system settings. Select No to exit the setting.
Diagnostics Menu (9/13): Firmware Rev
Displays the current firmware revision for the SunTouch system.
Menu button: Select the Diagnostics menu.
Right button: View the SunTouch system firmware revision.
Left button: Press the Left button to return to the main status screen.
Diagnostics Menu: Solar Temp
Displays the current solar temperature.
Menu button: Select the Diagnostics menu.
Right button: Press the button until Solar Temp displays. Use this feature for testing
purposes and to verify the sensor temperature is connected and operating correctly.
Left button: Press the Left button to return to the main status screen.
Diagnostics Menu: Self Test
To run a system self test:
Menu button: Select the Diagnostics menu.
Right button: Press the button until Enter Self Test displays.
Up/Down button: Select Yes to continue. Select No to exit the Diagnostics menu.
Right button: Start the SunTouch self test. The test includes testing the control
panel, air and water sensors and valves. Follow the on-screen instructions.
After the test has been completed, the status screen will displays the results. A
successful test will display - Status: Passed - Code: None.
Left button: Press the Left button twice to return to the main status screen.
Firmware Rev
Rev: 1.0
Main Menu 9/13
Diagnostics
Status: Passed
Code: None
Solar Temp
Temp: 77 F
Enter
Self Test? Yes
Main Menu 9/13
Diagnostics
Main Menu 9/13
Diagnostics
Reset Factory
Erase All? Yes
Main Menu 8/13
Advanced
Erase Memory?
[YES ]
SunTouch
7:30 AM