Pentair Pool and Spa Control System SunTouch, Installation And User Manual

Page: 14 / 88

6
SunTouch Pool and Spa Control System Installation and User’s Guide
Set Water Temp
Solar Only [Pool/Spa] System Mode
Temp: [40˚F - 104˚F or (4˚C - 40˚C)
Auto [Solar OFF, Solar ON]
System Control
Time Set: Hour/Minutes - AM/PM
Time Set
Start Temp Diff
Enabled: No [Yes] Solar Freeze
Temp Diff: [3˚ - 9˚F]
Temp Diff: [2˚ - 5˚F]
Enabled: No [Yes] Cleaner Freeze
StopTemp Diff
Enabled: No [Yes] Air Sensor
- optional air sensor Installed for freeze protection.
Adjusting the water temperature setting (Solar Only mode)
If you have already set the pool and spa water temperature in the “SET WATER TEMP” menu and you need
to adjust the water set point temperature, use the
(-) TEMP or (+) TEMP) buttons to adjust the water
temperature.
•
Press the (-) TEMP or (+) TEMP) button to lower or raise the set temperature to the desired level.
The water temperature can be adjusted from 40° F to 104° F (4° C to 40° C). When solar heat is
available SOL ON is displayed on the lower display line. SOLAR ON or SOLAR OFF indicates that
solar heat is available or not available. Degree units are displayed in either Fahrenheit or Celsius (see
page 22).
Note: To display the air temperature setting on the main screen, verify that the air
sensor is enabled in the Main menu, see “Advanced Menu,” on page 24.
Solar Only Menus
The following SunTouch main menu features are available when SunTouch is configured in “Solar Only” mode.
The main menu features are as follows:
Set Water Temperature
To set the water temperature:
Menu button: The Set Water Temp menu is displayed.
Up/Down button: Adjust to the desired set temperature from 40° F to 104° F or
(4° C to 40° C). This allows the solar system to heat the water up to set point
temperature. After the set point temperature is reached, the solar system is
automatically switched off.
To determine your optimum water temperature setting, set
the “Set Temperature” settings to 100° F and observe the water temperature over a
period of a few days. When the maximum desired temperature of the pool is reached,
set the temperature again. Once this setting is identified, it will not be necessary to
change the set temperature again
.
Left button: Press the Left button to return to the main status screen.
Solar Only Menus
The SunTouch “Solar Only” mode menus are shown below:
Set Water Temp
Temp: 81°F
WATER 71°F / 91°F
11: 51AM SOL ON
▼
Set
temperature
Lower water set
point temperature
Actual
temperature
Solar heat is
available
AIR 59°F
11: 51 AM
Raise water set
point temperature
Current air temperature (displays if optional
air sensor is enabled in the Solar Only menu)