High Power Wireless Link Kit Installation Guide
10
11
WARNING Switch OFF the main power to the Load Center
before making any connections.
3.
Unlatch the front door latch and open the front door. Remove
the two retaining screws from the High-Voltage Cover Panel and
remove the panel. See Figure 5 below.
4.
Loosen the two retaining screws securing from the top edge of
the Outdoor Control Panel. Fold down the Outdoor Control Panel
to access the circuit board sockets connectors for the electrical
connections. Remove the panel from the enclosure.
5.
Route the four conductor transceiver connection cable into the
lower plastic grommet, up through the low voltage raceway to the
system circuit board.
Figure 5. IntelliTouch
®
or EasyTouch
®
Control System Load Center
Retaining
screws
HIGH -VOLTAGE
FRONT COVER
PANEL
Outdoor
Control Panel
retaining
screw (x2)
Outdoor
transceiver|
communication
cable
(connect to
COM port)
Outdoor Control Panel
Grommet
(under side
of Load
Center
Inside Low
voltage race-
way
Latch
Connect the HPW Outdoor Transceiver Cable to the
RS-485 COM Port on Automation Control System
(Continued)