IntelliBrite
®
5g White Pool Light and White Spa Light Installation and User’s Guide
ite White light (after electrical requirements are met)
1.
Route light cable through conduit to Junction Box, leaving at least four (4)
feet of cable at the light fixture to coil around the light (this allows the light to
be serviced after the pool is filled with water). See Figure 1 below.
7
Figure 1.
To install the IntelliBrite light fixture:
INSTALLING THE INTELLIBRITE 5G WHITE POOL AND SPA LIGHT
FIXTURE (AFTER ELECTRICAL REQUIREMENTS ARE MET)
2.
Cut the cable at the Junction Box, leaving at least six (6) inches (2.4 cm) of
cord to make connections.
3.
Strip back six (6) inches (2.4 cm) of the outer cord jacket to expose the
three insulated conductors (be careful not to damage the insulation on the
three (3) inner conductors).
Strip a 1/2” of insulation off the three
conductors. Be careful not to damage the copper conductor.
4.
Connect all three (3) conductors to the corresponding circuit wires in the
Junction Box and secure the Junction Box cover in place.
