PressureMAT User Guide
Revision 8
Page 27/48
The Service Time is the number of hours the system has been in service. Pressing the
SELECT/PROG button will confirm a change- UNTIL THIS IS DONE, A SETTING
CHANGE IS NOT CONFIRMED. Pressing the HOME or BACK button before confirming a
setting change with the SELECT/PROG button will escape from that program menu without
saving changes made before confirming the entry.
Channel 4 Input Viewing
> * PV Qty 1 XXXXX.XX L
PV Qty 2 XXXXX.XX L
PV Rate 0.00 L/m
PV Signal 0 Hz
Service Time XXXX hrs
[SELECT] home display value
Input Programming
At this screen the UP/DOWN arrows are used to select what function to program. Press the
SELECT/PROG button to program the function. The setting or digit of a setting that can be
changed with the UP/DOWN arrows blinks. If there is more than one digit in a setting, use the
RIGHT/LEFT arrows to scroll within the possible digit locations within a setting. Pressing the
SELECT/PROG button will confirm a change- UNTIL THIS IS DONE, A SETTING
CHANGE IS NOT CONFIRMED. Pressing the HOME or BACK button before confirming a
setting change with the SELECT/PROG button will escape from that program menu without
saving changes made before confirming the entry.
IT IS ONLY RECOMMENDED THAT THE ITEMS IN SHOWN IN BOLD BELOW
ARE CHANGED. SCROLL TO SEE ALL SETTINGS:
Channel 4 Input Programming
> Port Type In Plse
Time Base min
Decimal Point xx.x
Measure Units L
Scale Factor 1.000
Pulse Constant 100000 p/L
PV Average 1.0 sec
Lo PV Alarm 0.00 L/min
Hi PV Alarm 0.00 L/min
Alarm Valid 002 sec
Qty1 Alarm 0.00 L
Qty2 Alarm 0.00 L
Time Alarm 0000 hrs
Comm Port Off
Log Type Off
Channel Name
Note: If the Alarm Points are set to 0.00 then there will be no alarm
After 30 seconds of inactivity in the program menu, the selected setting to change stops
blinking and the value before the setting was selected is restored.
