6. Wait until the LED starts flashing and then goes off
7. Release the button
iMPoRtant: this action will start a sensor recalibration
cycle; therefore, be careful not to touch the sensitive areas
until the LeD goes off.
During recalibration, watch the LED: it will light up briefly, go off
and then light up again for 3 seconds to indicate that the pro-
cedure was successfully completed. To check the configuration
of the battery module at any time, carry out the recalibration
procedure, keeping an eye on the LED.
Maintenance
The product requires no maintenance, except for replacement
of the rechargeable batteries as necessary. Any repairs must be
made by a technician authorized by Pellini SpA.
In the event of prolonged inaction, remove the batteries.
cLeaning
Clean the product using a clean, dry, soft cloth that does not le-
ave any residues. To remove stubborn dirt, you can slightly moi-
sten the cloth with warm water. Do not use solvent-containing
detergents. Do not clean the gold-plated contacts with alcohol
or other substances.
RePLacing the batteRieS
To replace the batteries use the following procedure:
1.
Detach the battery
module from the sup-
port
2.
Remove the battery
compartment cover
by pressing in the area
indicated and sliding
in the direction shown
3.
Remove the spent
batteries
10
