pela tools 506475, Manual

Page: 30 / 32

Troubleshooting
Important! If you are unable to solve the error on your own, do not hesitate to contact us,
order@pelatools.com. Please send a photo of your problem so it is easier for us to remedy the error and we
save time for everyone.
Problem Cause Measure
The engine does not run and
the lift is not raised.
The electrical wear has
loosened.
The engine has burned.
The limit switch is broken or
faulty in electrical connections.
Check and tighten.
Replace engine.
Repair and check connections,
replace limit switch.
The engine runs but the lift is
not raised.
The gear pump is broken.
The overflow valve has come
loose or is clogged.
The oil level is too low.
Oil hose is leaking or has come
loose.
The soft start valve has come
loose or is clogged.
Replace.
Adjust and / or clean.
Fill with oil.
Fasten and tighten.
Adjust and / or clean.
The lifting arms go down
slowly after they are raised.
An oil hose is leaking.
The oil cylinder is leaking.
The non-return valve is leaking.
The overflow valve is leaking.
The solenoid valve is leaking.
Tighten or replace.
Replace the gasket.
Clean or replace.
Clean or replace.
Clean or replace.
The lifting arms go up too
slowly.
The oil filter is clogged.
The oil level is too low.
The overflow valve is not set
correctly.
The hydraulic oil is too hot (>
45ºC).
The oil cylinder gasket is worn.
Clean or replace.
Fill with oil.
Clean or replace.
Replace the hydraulic oil.
Replace the gasket.
The lifting arms go down too
slowly.
The throttle valve is tight.
The hydraulic oil is dirty.
The hose break valve is tight.
Oil hose that is tight.
Clean or replace.
Replace the hydraulic oil.
Clean or replace.
Replace the hose.