Peg-Perego Aria, Instructions For Use Manual

Page: 14 / 56

- 14 -
EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
IMPORTANT: read these instructions carefully and
keep them for future use. The child’s safety could be
at risk if these instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_
WARNING
this seat unit is not suitable for children
under 6 months.
_ This item is approved for children from 6 months
up to a weight of 15 kg in the seat. Used as a Travel
System in combination with the Group 0+ car seat,
the age range is from birth up to a weight of 13 kg in
the seat.
_ This product was designed for use in combination with
the following Peg Perego Ganciomatic products: the
“Primo Viaggio Tri-Fix” car seat (Group 0+).
_ WARNING Check that the pram body or seat unit or car
seat attachment devices are correctly engaged before
use; check that the Peg Perego Ganciomatic products
are correctly fixed to the item.
_ When used in combination with car seat, this vehicle
does not replace a cot or a bed.
Should your child need to sleep, then it should be
placed in a suitable pram body, cot or bed.
_ The assembly and preparation of the product must be
carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system; Always use
the five point harness; always use the harness crotch
strap in combination with the waist strap.
_ WARNING Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_ WARNING To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING Do not let your child play with this product.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer’s instructions as regards the maximum
loads transportable.
_ The front bar is not designed to support the child’s
weight. It is not designed to keep the child in the seat
and does not substitute for the waist belt.
_ Do not load the baskets over 5 kg. Do not put weight
in the cup holder in excess of those indicated on the
cup holders themselves and never hot drinks. Do not
put loads of more than 0.2 kg in the hood pockets (if
present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ The use of accessories not approved by the
manufacturer could be dangerous.
_ Do not use the release levers to move or lift the stroller
when the child is in it.
_ WARNING This product is not suitable for running or
skating.
_ Apply the brake when loading or unloading children.
_
WARNING
do not add any matress.
_ WARNING Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
INSTRUCTIONS
1 OPENING: (fig_a) to open the stroller, release the two
connectors simultaneously, lift the handle upwards
sharply (fig_b) and then push it down again until it
snaps into place (fig_c).
If the front clips do not fasten properly, push down on
the seat until they click into place.
Once the stroller is open, use the magnets to attach
the fabric on the sides of the seat to the armrests.
2 FITTING THE REAR WHEELS: To mount the rear wheel
unit, press button 1 all the way down (fig_a) while
pressing on the wheels until they click into place
(fig_b).
3 FITTING THE FRONT WHEELS: To mount the front
wheels, lower the lever (fig_a) and click the wheels
into place (fig_b).
4 FITTING THE FRONT BAR: Attach the front bar as
shown in the figure.
5 HOOD: To attach the hood, insert the tabs into the
notches (fig_a) and button the hood to the rear of the
backrest (fig_b).
6 The hood can be moved to different positions while
your child is sleeping (fig_a). To remove the hood,
press the side buttons while lifting the hood off
(fig_b).
7 COVER: slide the cover on and button it at the side to
the arms of the stroller.
8 RAIN CANOPY: To fit the rain canopy, button the
elastic around the front uprights (fig_a), then button
the elastic around the base of the front uprights (fig_
b). This rain canopy has been designed for use with
the Primo Viaggio car seat attached to the stroller as
well, to guarantee total protection (fig_c).
_ Do not use the rain canopy in closed environments
and always check that the child is not hot.
_ Do not place rain canopy near sources of heat and
keep it away from cigarettes.
_ Make sure that the rain canopy does not block any
mechanism in movement in the chassis or stroller.
_ Always remove the rain canopy before closing your
chassis or stroller.
_ Wash with a sponge and soapy water, without using
detergents.
9 BRAKE: Press down on the brake lever situated on the
rear wheel unit to set the brake on the stroller. Lift the
lever to release the brake. Always set the brake when
the stroller is at a standstill.
10 5-POINT SAFETY HARNESS: to attach the safety
harness, insert the two buckles of the waist strap
(with shoulder straps attached) into the leg divider
strap until it clicks into place (fig_a). To release, press
both sides of the buckle and pull the waist strap to
the sides at the same time (fig_b).
11 To secure the child with the safety harness, insert
the shoulder strap buckle in the special holder on
the backrest (fig_a) and, after fastening the harness,
detach the buckle from the backrest to allow the
child more freedom of movement (fig_b). Position the
shoulder strap buckle just below the child's shoulders
to ensure the straps remain in place without slipping
(fig_c). To tighten the waist strap, pull on both sides in
the direction of the arrow (fig_d). To loosen it
do the opposite. The waist strap can be tightened as