ISSUED: 12-22-14 SHEET #: 180-9064-4 01-20-16
16
Multicast Mode - Pairing Additional Receiver(s) With The Transmitter (Optional)
Multicast Wireless Mode enables the Transmitter to stream AV media from one Transmitter to up to six Receivers.
Use the following instructions to pair the Receiver(s) to the current system, or follow the steps in the HDS300-R manual. The
system can have receivers added at any time.
Each Receiver will have to be paired with the Transmitter one at a time. Do not begin pairing another Receiver until the
previous Receiver has rebooted after pairing as described in the steps below. A maximum of 6 Receivers may be paired to one
Transmitter.
1. Press and hold the “Link/Source” button on the transmitter for 8 seconds. The lights will blink sequentially from top to
bottom. The transmitter will remain in pairing mode for 2 minutes or until it senses a Receiver trying to link.
2. Press and hold the “Link/Output” button on the desired Receiver for 8 seconds. The lights will
fi
rst blink sequentially from
top to bottom; then in various patterns. After about 30 seconds the Receiver will successfully link with the Transmitter and
then shut off and reboot itself. The entire process will take under 1 ½ minutes and video will not appear on the display until
the process is complete. Video on the additional paired Receivers will be lost during this process.
3. Repeat steps 1 and 2 for each additional Receiver, if any.
Note:
For 3 or more Receivers the system will change its mode from single channel to bonded channel. If Receivers are
removed from the system making it 2 or fewer Receivers total, the system should be factory reset to put it back into single
channel mode. Factory reset instructions can be found on page 16.
Peer-To-Peer LAN (Wired) Mode Installation
1. Connect the LAN cable between the LAN ports on the Transmitter and Receiver.
2. Plug both the Transmitter and Receiver into power.
3. When the PeerAir™ Pro system powers up it will detect the wired connection upon power up and not enter wireless mode.
The boot process should be complete in about 45 seconds. The WiFi indicator lights on the front of both the Transmitter
and the Receiver will be solid.
Available Multicast Models
Model
Capability
Mode
HDS300-2
streams to two display devices
Multicast Wireless
HDS300-3
streams to three display devices Multicast Wireless
HDS300-4
streams to four display devices
Multicast Wireless
HDS300-5
streams to
fi
ve display devices
Multicast Wireless
HDS300-6
streams to six display devices
Multicast Wireless
Note:
To return the units back to WiFi mode, unplug power on both
Transmitter and Receiver, then unplug the LAN cable, and re-
power the Transmitter and Receiver. The video and audio will
be lost during this process.
