Peco 54131501, Operator'S Manual, Page: 9 / 46

9
Mount Arm Assembly Installation
Note: Keep all hardware relatively loose until the end.
To install the Mount Arm Assembly (Item #2), align the bolt holes on the left side of the Mount Arm Assembly to those
on the Right Side Frame Bracket (Item #1). With the left side of the Mount Arm Assembly aligned, align the bolt holes
on the right side of the Mount Arm Assembly to those on the Side Rear Frame Bracket as well.
Loosely secure the Left side of the Mount Arm Assembly by removing and replacing the (2) 5/16”-18 x 1” Carriage
Bolts
(Item #5) and (2) 5/16”-18 Ny-Flange Lock Nuts (Item #6) that were kept loose from the Rear & Side Frame
Bracket Assembly in the previous section.
Secure the Right side of the Mount Arm Assembly by using (2) 3/8”-16 x 1-1/4” Carriage Bolt (Item #3) and (2) 3/8’-16
Ny-Flange Lock Nuts (Item #4). Tighten all hardware at this time.
Refer to the Figure Below.
Figure A