Peco 54131501, Operator'S Manual, Page: 20 / 46

20
Threaded
Boss
Blower
Cone Tab
Blower
Cone
Boot Kit Installation
Secure the Boot Plate (Item #2) to the Aluminum Boot (Item #1) using (2) 3/8”-16 x 1” Carriage Bolts (Item #3) and (2)
3/8”-16 Nylon Flange Locknuts (Item #4). Insert the bolts from the inside so that the threads are on top of the boot.
This will prevent grass clippings from collecting on the bolt threads. Leave the hardware loose until the boot assembly
has been attached to the mower deck. Refer to Figure A below.
Figure B
Figure D
Figure A
Blower Cone Installation
Thread (1) 5/16”-18 Jam Nut P#(K0120) onto each end
of (2) 5/16”-18 x 2-1/2” HHCS P#(K0125) as shown in
Figure A.
Now partially thread (1) bolt into each of the two
threaded bosses located on the Blower Housing. Place
8” Blower Cone P#(E6009) so the two tabs line up with
the bolts and tighten completely as shown in Figure B.
Thread (1) Jam Nut
Onto Each 5/16”-18 Bolt
Figure A
Once the (2) bolts are tight, tighten the Jam Nuts against
the threaded boss as shown in Figure C.
Refer to Figure D for proper Blower Cone installation
reference.
(1st) Tighten
Bolt
(2nd) Tighten
Jam Nut
Figure C