Peco 54131501, Operator'S Manual, Page: 24 / 46

24
WARNING
!
To Prevent Serious Injury-
Proper Installation Of Safety Interlock Harness
Is Mandatory. Please Check That All Interlock
Points Work Correctly Once Installed.
Figure A
(#2) PTO Switch
(#3) Positive (+)
Terminal Connection
(Battery “+” )
(#4) Negative (-)
Terminal Connection
(Battery “-” )
(2) 1/4”-20 x 1/2”
SIHWH
(#1) Quick Connect Plug
Route, the end of the wire harness
down the side of the mower towards
the PTO-X Unit
Wire Harness Installation
Note: Refer to Figure B on the next page for the
complete Wire Harness (P# P0291) drawing and
breakdown.
Route the 2 Way Metri-Pack Connector (P# P0280)
around the front side of the engine, between the ROPS
and the engine, through the opening in the rear bumper.
Connect the Connector to the Quick Connect Plug
(#1)
located on the PTO Drive. Refer to Figure A.
Attach the Positive Lead from the Main Harness (P#
A2144) connected to the Metri-Pack 2 Way Connector
(P# P0280) to the PTO Switch (P# J2001) by connecting
the Female Disconnector (P# P0106) from the Positive
Lead to the Switch Terminal (A) on the Switch. Refer to
Figure B.
Insert the PTO Switch in and through the PTO Switch
Bracket (P# B1020) then attach and secure the Safety
Cover (P# P0073).
Before routing the PTO Switch (#2) , determine where on
the right mower side panel the PTO Switch should be
attached. It is recommended to attach the PTO Switch
close to the control panel of the mower for ease of
access. To attach the PTO Switch, pre tap two holes for
the (2) 1/4”-20 x 1/2” Slotted Indented Hex Washer Head
Screws that are provided. Attach the PTO Switch
Bracket by sliding it behind the (2) Slotted Indented Hex
Washer Head Screws and tightening the hardware.
Refer to Figure A.
Connect the Switch Harness (P# A2145) to the PTO
Switch by connecting the Female Disconnector (P#
P0106) to the Switch Terminal (B) of the PTO Switch.
Refer to Figure B.
Route the PTO Switch to the positive terminal of the
battery
(#3) using the Ring Terminal (P# P0086) of the
Switch Harness (P# A2145) to secure the attachment.
Route the Main Harness to the negative terminal of the
battery
(#4) using the Ring Terminal of the Negative
Lead to secure the attachment. Refer to Figure A.
Use the Cable Ties (P# J0245) that are provided to
secure the Wire Harness.