ix. SIDE TABLE & SPLASH
GUARD INSTALLATION
Install the side table and splash guard as shown in
the illustration to the side. Fasten the knobs/screws
respectively to the saw frame.
1. Remove the water pump from the box and check
that it is not damaged.
2. Place the water pump into the bracket at the left
front corner of the water tray, as shown on right.
3. Position the water outlet of the pump so that it lays
horizontally. Connect the water hose from the blade
guard to the water pump.
4. Plug the power cord into the 3-prong receptacle
coming from the power switch housing.
A tube at the rear end of the saw filters the debris from
the water produced during the cutting operation. Debris
settles in the water tray while the water is allowed to
pass through the tube and into the water bucket, where
fresh and filtered water reside.
1. Remove the water level tube from the plastic bag.
2. Insert the thin end of the tube into the rear hole next
to the water pump, as shown in the illustration.
3. Fill the water tray with water.
The Adjustable Angle Guide is
a
two-piece
assembly
consisting of a base and an
attachment that rotates. This
guide will support cutting
angles between 0°, 22.5°, 30°,
45° and many more. The
attachment has a casted angle
indicator that show what angle
the Angle Guide is currently
set to support.
xi. OVERFLOW PLUG
INSTALLATION
xii.
THE ADJUSTABLE
ANGLE GUIDE
Disconnect the pump
before attempting to handle the pump.
Never operate pump without water in
the tray.
WARNING!
x. WATER PUMP
INSTALLATION
Set
Angle
Indicator
– 10 –
