Using the RBM-20 to trigger sounds from a software drum module:
1. Connect the module’s USB port to your computer with
a standard USB cable. (Alternatively, you could connect
the
MIDI OUT
of the RBM-20 to the MIDI IN of a
MIDI interface connected to your computer, but we recommend
using your computer’s USB connection if it is available.)
2. Press
UTILITIES
to access the module’s UTILITIES Menu.
3. Press
MIDI (F2)
to access the MIDI settings.
4. Press
OUT (F3)
to access the MIDI output settings.
5. Use
CURSOR UP / DOWN
to move through the menu
items and
DEC- / INC+ or the VALUE / TEMPO DIAL
to
adjust the settings accordingly:
a. Prog Chng:
“
SENT
” (so the RBM-20 can send
Program Change messages to the software).
b. Clock Out:
“SENT” (if you want the RBM-20’s MIDI
clock to the be the “master” clock) or “
NOT SENT
” (if
you do not want the RBM-20 to send out MIDI clock information).
c. MIDI Thru:
“OFF.”
6. Set your software to receive MIDI messages from the RBM-20 module
(“
USB Audio Device
”). Consult your software’s manual for more information.
33
32
Note:
These are just recommended
settings. You may configure the
RBM-20’s MIDI settings however
best suits your performance
needs. See the MIDI section of the
UTILITIES MENU chapter and the
KIT SELECT SETUP section of the
KITS, VOICES, ACCOMPANIMENT &
INSTRUMENTS chapter for
more information.
34
