Pearl Abrasive VXRS RAIL SAW, Owner'S/Operator'S Manual

Page: 17 / 20

– 17 –
PROBLEM POSSIBLE CAUSE SOLUTION
- Wrong type of saw blade.
- Shaft of motor causes wobbling.
- Overheating.
- Saw blade type is unsuitable for the
material being cut.
- Saw blade ype is unsuitable for the
machine performance.
- Saw blade too hard.
- Diamond segments are blunt.
- Poor tension in the blade material.
- Too much load placed on the saw
blade.
- Diamond segments are blunt.
- The saw blade has slipped on the
motor shaft when running.
- Saw blade overheating due to a lack
of cooling water.
- Lateral friction when cutting.
- Material is not being fed parallel to
the saw blade
- Poor tension in the blade material.
- Too much load on the saw blade.
- Use harder saw blades.
- Have bearings of the motor or the
motor replaced.
- Ensure optimum flow of cooling
water.
- Use appropriate type of saw blade.
- Sharpen the diamond saw blade.
- Return the saw blade to the
manufacturer.
- Use a suitable saw blade.
- Sharpen the saw blade.
- The arbor of the saw blade must be
fitted with an appropriate adator
ring.
- Check the receiving flange and have
it replaced if necessary.
- Ensure an optimum flow of cooling
water.
- The material feed is too high;
proceed more slowly.
- Ensure that the direction of feed is
absolutely parallel to the saw blade.
- Adjust the roller table or have it
adjusted.
- Have the saw blade tensioned.
- The material feed is too high,
proceed more slowly.
EXCESSIVE WEAR
APPEARANCE OF CUT
IS NOT OPTIMAL
THE CENTER HOLE IN THE SAW
BLADE HAS BECOME WIDER DUE
TO WEAR
SAW BLADE SHOWS BLOOMING
COLORS
GRINDING MARKS ON THE
SAW BLADE