Pearl Abrasive VXRS RAIL SAW, Owner'S/Operator'S Manual

Page: 7 / 20

– 7 –
UNPACK
Open the container, carefully lift the saw frame handles
and place it on a flat, level working area. Be certain that
you have the following items before you discard the
container:
Saw Water Pump
Fold-in Legs with Wheels Water Level Tube
10" Saw Blade Owner’s Manual
Multiple Rip Guide Drain Plug
Multiple Wrench Bucket
Proceed to the following section to complete
assembly of the saw.
ASSEMBLY & SET-UP
a. Remove the carton box cover from the
wooden frame.
b. Remove saw from the crate.
c. Loosen the lock knob on top of the cutting head.
d. Install the side extension table, side splash guard
and back splash guard.
e. Install the spring holder on top of the sliding rail
to hold the power cable and the water hose
f. Fill the tray with water before operating the saw.
1. FOLD-IN LEGS
a. Lifting up one side of the saw, slide in the legs
(with no wheels) to the front side of the saw.
Lock the wing nut to tighten the legs in place.
b. Lift up the other side of the saw and slide in the
legs with the wheels. Lock the wing nut to
fasten the legs in place.
2. EASY TRANSPORT
a. Unlock the wing nut. Lift up the back side of the
saw and slide the legs with wheels,lock the
wing nut.
b. Go to the other side of the saw and unlock the
wing nut. Lift up the other side of the saw and
insert the legs, lock the wing nut. Using the legs
as handles, tilt the saw diagonally and roll the
saw on the wheels like a dolley.
a. Loosen the knurled nuts securing the blade
guard and remove the guard.
b. Loosen the cutting shaft nut (left-hand thread);
while loosening the nut, block the cutting shaft
from turning.
c. Remove the blade clamping flange. Check that
the contact area between the blade holder
assembly and the diamond saw blade is clean.
d. Install the saw blade on the supporting flange,
ensuring the correct sense of rotation marked
by the arrow on the blade.
e. Install the blade clamping flange.
f. Retignten the cutting shaft nut. Block the
cutting shaft form turning while tightening
the nut.
g. Lightly turn the installed saw blade by hand and
check the blade for true running.
h. Mount the blade guard.
vi. UNPACK, ASSEMBLY & SET-UP
Knurled
Nuts
Figure 1
vii. SAW LEGS ASSEMBLY
viii. BLADE INSTALLATION
Setting the blade too
low may damage the cutting table and if
set too high, the blade may grab the
material being cut, causing damage and
possibly injury.
WARNING!