2. Introduction
The PeakTech 6180 is a high-performance programmable linear DC Power Supply. The outstanding features of this
instrument include up to 100 programmable output steps with configurable timer, high-resolution TFT colour display,
extremely low ripple and noise characteristics, comprehensive over-voltage, over-current and over-temperature
protection, user friendly interface and panel layout. Furthermore, the P 6180 has a variety of standard interfaces to meet
diverse test requirements.
Features
Dual independent & separate control outputs
Line regulation: ≤ 0.01%+3mV, ≤ 0.1%+3mA
Load regulatio
n: ≤ 0.01%+3mV, ≤ 0.2%+3mA
Low ripple noise: ≤ 300µVrms / 2mVpp
Four operating modes: independent, parallel, series, plus-minus
Up to 100 output steps programmable
High resolution and accuracy
3,9
“ inch TFT LCD (480x320 pixels)
Interfaces: USB 2.0 Host, RS232
Safety Terms
The following terms may appear in this manual:
Warning:
Warning indicates the conditions or practices that could result in injury or loss of life.
Caution:
Caution indicates the conditions or practices that could result in damage to this product or
other property.
Terms on the Product
The following terms may appear on this product:
Danger:
It indicates an injury or hazard may immediately happen.
Warning:
It indicates an injury or hazard may be accessible potentially.
Caution:
It indicates a potential damage to the instrument or other property might occur.
Safety Symbols
The following symbols may appear on the product or in this manual:
Hazardous Voltage
Refer to Manual
Protective Earth Terminal
Chassis Ground
Public Ground
NOTE:
Laboratory Power Supplies are not designed for charging batteries. Any use of this type can cause serious damage to the
device, which are exempt from any legal claims whatever.
-29-
