10
6) Setting the waveform amplitude
(1) AMP (Amplitude): 0 to 999
*
The amplitude may be set from 0 to 10 V
pp
(in to a 50
Ω
load) in a scale from 0 to 999.
* To set the Amplitude of a waveform:
(a) Press [AMP] Button. Display: “AMP:___
◀
”. Note: If the
generator is in the Sweep mode, press the F5 button to move
the cursor to the AMP symbol.
(b) When the Rotary dial is turned counter clockwise, the cursor
changes to a (
gh
) symbol.
(c) Rotate the dial until the digit to be changed is highlighted.
(d) Press the
button to select digit edit mode cursor (
v
).
(e) Turn the Rotary dial to change the digit value. The highlighted
digit will increase if the rotary dial is turned clockwise; counter
clockwise decreases the digit value.
(f) To change another digit press the
button, turn the rotary
dial to highlight the next digit to be changed and repeat steps (1e
and 1f).
(2) OFS (DC Offset): -999 to 999
*
The DC off offset adds a 0 to
±
7.5 V DC level (no load) to the waveform in a
scale from –999 to +999
* To change the Offset.
(a) Press [OFS] Button. Display: “OFS:___
◀
”.
(b) To set the offset Volt use the same procedure in 6) steps (1b, 1c,
1d, 1e and 1f) Setting the waveform amplitude.
(3) ATT (Attenuator): 0 dB or 20 dB
* To change the Attenuator.
(a) Press the
Button to display the selection mode cursor(< or >).
(b) Turn the rotary dial until the cursor indicates “ATTN: ____”
(c) Press the
button to change the cursor to the edit mode (
◄
or
►
).
(d) Rotate the rotary dial to display the new Attenuator.
(4) SYM (Symmetry): 0.00 to 99.9
▣
The waveform symmetry can be adjusted from 1:1 to 10:1 in a scale from 00.0 to 99.9
* To change the Symmetry.
(a) Press [SYM] Button. Display: “SYM:___
◀
”.
(b) To set a Symmetry value, use the same procedure in 6) steps
(1b, 1c, 1d, 1e and 1f) Setting the waveform amplitude
