9
(2) The cursor can be used to change numerical values (Frequency, amplitude, symmetry, offset
values) by indicating the setting to be changed with the selection cursor (< or >), and then
pressing the
Button to display the edit cursor (
◄
or
►
). Rotating the rotary dial changes
the cursor to the digit selection cursor displayed as a (
gh
) symbol and highlights a digit.
Turning the rotary dial further moves the highlight to the next consecutive digit. Pressing the
Button on the highlighted (selected) digit changes the cursor to the Digit edit cursor
displayed as a (
v
) symbol. Turning the rotary dial clockwise increases the digit value; counter
clockwise decreases the digit value.
(3) The cursor is also displayed in the Menu when the edit button is pressed is used to change
settings and data values using the procedures in the above paragraph
2) WAVE FORM
* Displays the currently selected WAVE FORM.
* SINE, TRI or SQURE may be selected and displayed.
* To change the Wave form.
(a) Press the
Button to display the selection mode cursor(< or >).
(b) Turn the rotary dial until the cursor indicates “WAVEFORM: ____”
(c) Press the
button to change the cursor to the edit mode (
◄
or
►
).
(d) Rotate the rotary dial to display the new wave form.
3) Output status
* The output status displays whether the output is ON or OFF
* To Turn the output ON/OFF
(a) Press the F1 Button.
(b) Pressing this button again will turn the unit ON/OFF.
4) (Lock)
* When displayed, all front panel buttons except the [MENU] are disabled:
* To unlock (or lock) the front panel press the [MENU] [F4] buttons
5) Setting a frequency value
* Range : 1 Hz to 15 MHz
* To change the frequency value.
(a) Press [FRQ] Button. Display: “____Hz
◀
”.
(b) When the Rotary dial is turned counter clockwise, the cursor
changes to a (
gh
) symbol.
(c) Rotate the dial until the digit to be changed is highlighted.
(d) Press the
button to select digit edit mode cursor (
v
).
(e) And turn the Rotary dial to change the digit value. The
highlighted digit will increase if the rotary dial is turned clockwise;
counter clockwise decreases the digit value.
(f) To change another digit press the
button, turn the rotary
dial to highlight the next digit to be changed and repeat steps (1e
and 1f).
