13
Adjusting the Risers
The Risers have 12 scaled positions and 1 storage position.
The Riser positions are scaled so both Risers can be easily
adjusted to the same height.
To adjust the Risers:
Pull the Riser Pull Pin and move the Riser up or down to
1.
the desired position.
Release the Riser Pull Pin to lock.
2.
Set the Riser on the other side of the machine to the
3.
same position.
To store the Risers:
Flip the pulleys 90 degrees from their normal position.
1.
The pulleys will then face towards the center of the unit.
Retract the Pull Pins and drop the Risers as far down as
2.
it will go. They will rest on the telescoping Lift Handle.
Caution: Make sure that the Riser Pull Pin is fully
engaged before beginning any exercises.
Converting to Mat—with or without Tower
The Mat Set includes two mats, one for the head end of the
machine and one for the foot end. The Foot End Mat is
identified by the Foot Strap included at one of its ends.
MVe Reformers have been manufactured using one of two
types of Gear Bars. The earlier units incorporated a Gear Bar
that was oblong in shape and is called a no revision machine.
The Gear Bar on the newer units is round and is called a
Rev 1 or Rev 2 machine. After completing steps numbered 1
and 2 below, all users of Rev 1 or Rev 2 machines should go
to either Step 3 (with Tower) or 4 (no Tower). All users with a
no revision machine should go to either Step 5 (with Tower) or
Step 6 (without Tower).
TO ADJUST THE RISERS
TO STORE THE RAISERS
Operating the MVe
®
Reformer Tower
MVe_Tower_Owners_Manual-10_09.indd 13
12/4/09 4:21:29 PM
